NEC NP60 User Manual
Also see for NP40: SpecificationsSupplementary guideControl commandsControl commandsPlacement recommendations guide
                                                                          | |
Contents
| 
17SOURCEAUTOADJ.ON/STAND BYFOCUSLAMPSTATUSPOWER SELECTSOURCEAUTOADJ.ON/STAND BYFOCUSLAMPSTATUSPOWER SELECTEXITMENUUPPAGEOFFPOWERONPIC-MUTEDOWNFOCUSENTER3. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)When you first turn on the projector, you will get the Startup menu. The menu gives you the opportunity to selectthe menu in one of the nine languages.To select a menu language, follow these steps:1. Use the SELECT ▲ or ▼ button to select one of thenine languages from the menu.2. Press the ENTER button to execute the selection.After this has been done, you can proceed to the menu op-eration.If you want, you can select the menu language later. (→ [Lan-guage] on page 41)NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamplighting is stabilized.When the [Lamp mode] is set to [Eco], the LAMP indicator will light green.If one of the following things happens, the projector will not turn on.• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In thiscondition the projector will not turn on to protect the internal system. If this happens, wait for the projector's in-ternal components to cool down.• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minuteand then turn on the power.ENTER EXITMENUUPPAGEOFFPOWERONPIC-MUTEDOWNFOCUS |
Related manuals for NEC NP40
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine