NEC NP60 User Manual

Also see for NP40: Specifications Supplementary guide Control commands Control commands Placement recommendations guide

Contents

NEC NP60 User Manual Manual pdf 34 page image

26SELECTAUTOADJ.ON/STAND BYFOCUSLAMPSTATUSPOWER SOURCE3. Projecting an Image (Basic Operation)[Poor picture][Normal picture]➏ Optimizing RGB Picture AutomaticallyAdjusting the Image Using Auto AdjustThis adjustment may be necessary when you connect your computer for the first time.Adjusting with buttons on the cabinet• Press the SELECT ◀ button with no menus displayed.An RGB image will be optimized automatically after a few seconds.Adjusting with the remote control• Press the AUTO ADJ. button to optimize an RGB image automatically.NOTE:Some signals may take time to display or may not be displayed correctly.The Auto Adjust function does not work for component and video signals.If the Auto Adjust operation cannot optimize the RGB signal, try to adjust Horizontal/Vertical Position, Clock and Phase manu-ally. (→ page 40)If performing the Auto Adjust function does not correct image positioning, vertical stripes (banding) or horizontal noise, per-form the [Horizontal], [Vertical], [Clock] or [Phase] function from the menu to optimize the image. (→ page 40)Performing the [Horizontal], [Vertical], [Clock] or [Phase] function will store the adjustment values of the currently projectedsource into the projector’s memory.The next time the same source (same resolution, horizontal and vertical frequencies) is projected; the projector will call upfrom memory the stored values for the source.To clear the stored adjustment values, select the [Reset] → [Current Signal] or [All Data] from the menu to reset the adjust-ment values.••••••LAMP MODEVOLUMES-VIDEOVIDEOL-CLICKMOUSER-CLICKAUTO ADJ.COMPUTERASPECT HELPFREEZEPICTURE4. Correct the vertical distortion.Use the SELECT ◀ or ▶ button to correct the verticalkeystone distortion.NOTE: The Keystone Correction feature can cause an imageto be slightly blurred because the correction is made elec-tronically.5. Press the EXIT button twice to close the menu.TIP: You can save the changes using the Keystone Savefeature when you turn off the projector. (→ page 41)