NEC NP60 User Manual

Also see for NP40: Specifications Supplementary guide Control commands Control commands Placement recommendations guide

Contents

NEC NP60 User Manual Manual pdf 56 page image

48➌ Replacing the Lamp and the Cooling PumpAfter your lamp has been operating for 2000 hours (up to 3000 hours in Eco mode) or longer, the LAMP indicatorin the cabinet will blink red and the message [The lamp has reached the end of its usable life. Please replacethe lamp.] will appear. Even though the lamp may still be working, replace it at 2000 (up to 3000 hours in Ecomode) hours to maintain optimal projector performance. After replacing the lamp, be sure to clear the lamp hourmeter. (→ page 46)CAUTION• The optional lamp comes with the cooling pump.After replacing the lamp, be sure to replace the cooling pump, too.• DO NOT TOUCH THE LAMP immediately after it has been used. It will be extremely hot. Turn the projector offand then disconnect the power cable. Allow at least one hour for the lamp to cool before handling.• DO NOT REMOVE ANY SCREWS except two lamp case screws. You could receive an electric shock.• Do not break the glass on the lamp housing.Keep finger prints off the glass surface on the lamp housing. Leaving finger prints in the glass surface mightcause an unwanted shadow and poor picture quality.• The projector will turn off and go into standby mode after 2100 (up to 3100 hours in Eco mode) hours of ser-vice. If this happens, be sure to replace the lamp. If you continue to use the lamp after 2000 hours (up to 3000hours in Eco mode) of use, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case.Do not touch them as the pieces of glass may cause injury. If this happens, contact your NEC dealer for lampreplacement.To replace the lamp:Optional lamp, cooling pump and tools needed for replacement:• Replacement lamp with cooling pump: NP03LP (NP60) or NP02LP (NP50/NP40)• Phillips screwdriver or equivalent1. Place the projector on a soft cloth and turn it over to access the lamp cover on the bottom.6. Maintenance2. Loosen the lamp cover screw until the screwdriver goes into a freewheeling condition and remove thelamp cover.The lamp cover screw is not removable.