ISSUE 1.05-18 Recording and Capture Settings2. Select Advanced on the left side menu.Verify if the storage mode of the HDD is set to Group. If not set to group, set it now.For detailed information, refer to Chapter 13, Section 4 Managing HDD Group.3. Select General in the left side menu.4. Click to access the editing screen.5. Configuring the HDD group.5a. Choose a group number for the HDD group.5b. Click Apply. In the pop-up message box click Yes to save your settings.5c. Click OK to return to the upper level menu.Repeat the above steps to configure additional HDD groups.6. Choose the Channels that you want to save the record files and captured pictures inthe HDD group.6a. Select Advanced on the left bar.6b. From the Record on HDD Group dropdown list choose the Group number.6c. Check the channels you want to save in this group.6d. Click Apply to save the settings.Figure 5-28 Storage ModeNOTE After having configured the HDD groups, you can configure theRecording and Capture settings following the procedure provided in:❍ Section 2 Configuring Parameters on page 5-1❍ Section 3 Configuring the Recording and Capture Schedule onpage 5-5❍ Section 4 Configuring Motion Detection Recording and Captureon page 5-9❍ Section 5 Configuring Alarm Triggered Recording and Capture onpage 5-11❍ Section 6 Enabling/Disabling Manual Recording and ContinuousCapture on page 5-13❍ Section 7 Configuring Holiday Recording and Capture on page5-14
