182. Projecting an Image (Basic Operation)Adjusting the vertical position of a projected image (Lens shift)CAUTION Perform the adjustment from behind or from the side of the projector. Adjusting from thefront could expose your eyes to strong light which could injure them.Turn the lens shift dials clockwise or counterclockwise.Vertical dialTurn this clockwise or counterclockwise to adjust the projection position in the vertical direction.Approximate turning range: About 6 turns counterclockwise, about 2 turns clockwise when the lens is at the centerposition.Horizontal dialTurn this clockwise or counterclockwise to adjust the projection position in the horizontal direction.Approximate turning range: About 1 turn counterclockwise, about 1 turn clockwise when the lens is at the centerposition.NOTE:• The dials can be turned more than one full turn, but the projection position cannot be moved more than the range indicated onthe following page.• If the lens is shifted to the maximum in the diagonal direction, the edges of the screen will be dark or shaded.• The vertical shift adjustment must be finished with an image shifted upward. If you finish the vertical shift adjustment with animage shifted down, the zoom/focus adjustments or strong shaking may cause a projected image to slightly shift down.• The lens shift function cannot be used when using the separately sold NP11FL lens.DownwardUpwardLens shift dial (Horizontal)Lens shift dial (Vertical)RightwardLeftward
