1065. Using On-Screen Menu[INSTALLATION(2)]Disabling the Cabinet Buttons [CONTROL PANEL LOCK]This option turns on or off the CONTROL PANEL LOCK function.NOTE:• This CONTROL PANEL LOCK does not affect the remote control functions.• When the control panel is locked, pressing and holding the EXIT button on the projector cabinet for about 10 seconds will changethe setting to [OFF].TIP: When the [CONTROL PANEL LOCK] is turned on, a key lock icon [ ] will be displayed at the bottom right of the menu.Enabling Security [SECURITY]This feature turns on or off the SECURITY function.Unless the correct keyword is entered, the projector cannot project an image. (→ page 37)NOTE: Your setting will not be affected even when [RESET] is done from the menu.Selecting Communication Speed [COMMUNICATION SPEED]This feature sets the baud rate of the PC Control port (D-Sub 9P). It supports data rates from 4800 to 115200 bps.The default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on theequipment, a lower baud rate may be recommended for long cable runs).NOTE:• Select [38400bps] or less when using the supplied software programs.• Your selected communication speed will not be affected even when [RESET] is done from the menu.Turning On or Off Remote Sensor [REMOTE SENSOR]This option determines which remote sensor on the projector is enabled in wireless mode.The options are: FRONT/BACK, FRONT, and BACK.If the remote control system does not function when direct sunlight orstrong illumination strikes the remote control sensor of the projector, change another option.Setting ID to the Projector [CONTROL ID]You can operate multiple projectors separately and independently with the single remote control that has the CONTROLID function. If you assign the same ID to all the projectors, you can conveniently operate all the projectors togetherusing the single remote control. To do so, you have to assign an ID number to each projector.CONTROL ID NUMBER �������Select a number from 1 to 254 you wish to assign to your projector�CONTROL ID �����������������������Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-ting�Downloaded From projector-manual.com NEC Manuals
