1105. Using On-Screen Menu[OPTIONS(2)]Selecting Power-saving in [STANDBY MODE]The projector has three standby modes: [NORMAL], [POWER-SAVING] and [NETWORK STANDBY].The POWER-SAVING mode is the mode that allows you to put the projector in the power-saving condition whichconsumes less power than the NORMAL mode. The projector is preset for NORMAL mode at the factory.NORMAL�����������������������������Power indicator: Orange light/STATUS indicator: Green lightPOWER-SAVING �����������������Power indicator: Red light/STATUS indicator: OffThe following connectors, buttons or functions will not work during this mode�- MONITOR OUT (COMP� 1) connector, and AUDIO OUT connector- LAN and Mail Alert functions- Buttons other than POWER button on the cabinet- Buttons other than POWER ON button on the remote control- Virtual Remote Tool fucntionNETWORK STANDBY ����������When in the standby mode, the POWER indicator will light orange and the STATUS indicator willnot light� This shows that the projector’s power can be turned on by wired LAN�When in the standby mode, the following connectors, buttons or functions will not work:- MONITOR OUT (COMP� 1) connector, and AUDIO OUT mini jack- Wireless LAN Unit- [AUTO POWER ON (COMP1/3)]- Buttons other than POWER button on the cabinet- Buttons other than POWER ON button on the remote control- PC control commands for other than power-onImportant:• When [CONTROL PANEL LOCK] or [CONTROL ID] is turned on, or when [COMPUTER 1] or [COMPUTER 3] is selected for [AUTOPOWER ON(COMP1/3)], the [STANDBY MODE] setting becomes invalid.This means that the projector is in the same condition when the [NORMAL] is selected for [STANDBY MODE].NOTE:• Even when [POWER-SAVING] is selected for [STANDBY MODE], power on or off can be done by using the PC CONTROL port.• The power consumption in the standby mode will not be included in calculating CO2 emission reduction.• Your setting will not be affected even when [RESET] is done from the menu.Enabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.Downloaded From projector-manual.com NEC Manuals
