1275. Using On-Screen Menu[SOURCE OPTIONS]Setting Auto Adjust [AUTO ADJUST]This feature sets the Auto Adjust mode so that the computer signal can be automatically or manually adjusted fornoise and stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].OFF ������������������������ The computer signal will not be automatically adjusted� You can manually optimize the computer signal�NORMAL���������������� Default setting� The computer signal will be automatically adjusted� Normally select this option�FINE ����������������������� Select this option if fine adjustment is needed� It takes more time to switch to the source than when [NOR-MAL]is selected�TIP:• The default setting when shipped from the factory is [NORMAL].• When the AUTO ADJ. button is pressed, the same [FINE] adjustment is carried out.[COLOR SYSTEM]This feature allows you to select the TV video signal, which differs from country to country (NTSC, PAL, etc.).This is set to [AUTO] by factory default. Set this if the projector cannot identify the signal automatically.[AUDIO SELECT]This selects the audio input of the HDMI 1 IN terminal, HDMI 2 IN terminal, DisplayPort input terminal and Ethernet/HDBaseT port*.When inputting analog audio, connect the audio output terminal of the connecting device with the BNC audio inputterminal and set the Audio Select to “BNC”.* For MM models, use the HDMI 1 input terminal, HDMI 2 input terminal, DisplayPort input terminal, Ethernet port, USB-A port.
