433. Convenient FeaturesWhen videos cannot be viewed in 3DPlease check the following points when videos cannot be viewed in 3D.Please also read the operating manual attached to the 3D eyewear.Possible reasons SolutionsThe selected signal does not support 3D output� Please change the video signal input to one that supports 3D�The format for the selected signal is turned to [OFF(2D)]� Please change the format in the on-screen menu to [AUTO] or aformat that supports 3D�A eyewear that is not supported by the projector is being used� Please purchase a commercially-available 3D eyewear or 3D emitter(recommended)� (→ page 41)Please check the following points when a video cannot be viewed in3D using a 3D eyewear that is supported by the projector�The power supply of the 3D eyewear is turned off� Please turn on the power supply of the 3D eyewear�The internal battery of the 3D eyewear is flat� Please charge or replace the battery�The viewer is located too far away from the screen� Please get closer to the screen until the video can be seen in 3D�Please turn the L/R INVERT in the on-screen menu to [OFF]�Due to multiple 3D projectors working at the same time in the vi-cinity, the projectors may interfere with one another� Alternatively,there may be a bright light source near the screen�Please maintain sufficient distance between the projectors�Please keep the light source away from the screen�Please turn the L/R INVERT in the on-screen menu to [OFF]�There is an obstacle between the optical receiver of the 3D eyewearand the 3D emitter�Please remove the obstacle�The 3D format of the 3D video contents is not supported� Please check with the company selling the 3D video contents�
