71. Introduction❸ Part Names of the ProjectorFront/TopThe lens is sold separately. The description below is for when the NP13ZL lens is mounted.Controls(→ page 9)Lens Shift Dial (vertical/horizontal)(→ page 21)LensRemote Sensor (located on thefront and the rear)(→ page 13)Remote Sensor(→ page 13)Zoom Lever/Zoom Ring (→ page25)Lens Cap(The optional lens is shipped withthe lens cap.)Focus Ring(→ page 22)Adjustable Tilt Foot(→ page 25)Indicator Section(→ page 9)Securing lever cover(→ page 168)Lens Release Button(→ page 156)Adjustable Tilt Foot(→ page 25)Exhaust ventHeated air is exhausted from here.Mounting the strap1. Mount the strap to the filter cover and lamp cover as shown on the diagram below.2. Insert the knot in the strap into the hole on the bottom of the projector and pull in the direction of the arrowto fasten.a bHow to paste the input selection character sticker of the remote control• Peel off the cover of the sticker and align the sticker holes with Buttons 1 to 6 before pasting.• Please take care not to let the sticker contact the buttons when pasting.• The explanations and illustrations in this manual are provided with the sticker pasted.Lamp Cover (→ page 178)Security BarAttach an anti-theft device.The security bar accepts securitywires or chains up to 0.18 inch/4.6mm in diameter.Monaural Speaker (10 W)
