101. IntroductionTerminals2 3112 8 910 11745 15 1613 14 6101. HDMI 1 IN Connector (Type A)(→ page 158, 160, 164)2. HDMI 2 IN Connector (Type A)(→ page 158, 160, 164)3. DisplayPort IN Connector(→ page 158)4. BNC IN [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Connec-tors (BNC × 5)(→ page 157, 162)5. BNC (CV) Input Connector (BNC × 1)(→ page 162)6. BNC (Y/C) Input Connector (BNC × 2)(→ page 162)7. BNC AUDIO IN Mini Jack (Stereo Mini)(→ page 160, 162)8. COMPUTER IN/ Component Input Connector(Mini D-Sub 15 Pin)(→ page 157, 163)9. COMPUTER AUDIO IN Mini Jack (Stereo Mini)(→ page 157, 163)10. Ethernet/HDBaseT Port (RJ-45) [HDBaseT Mod-els](→ page 165, 169)Ethernet Port (RJ-45) [MM Models](→ page 169)11. USB-A Port (Type A)(→ page 225)(HDBaseT Models: For future expansion. This portallows for power supply.)12. HDMI OUT Connector (Type A)(→ page 161)13. AUDIO OUT Mini Jack (Stereo Mini)(→ page 161)14. 3D SYNC Connector (Mini DIN 4 Pin)(→ page 41)15. PC CONTROL Port (D-Sub 9 Pin)(→ page 269)Use this port to connect a PC or control system.This enables you to control the projector using serialcommunication protocol. If you are writing your ownprogram, typical PC control codes are on page 275.16. REMOTE Connector (Stereo Mini)Use this connector for wired remote control of theprojector using the NEC remote control for PX750U/PH1000U/PH1400U series.Connect the projector and optional remote controlusing a commercially available wired remote controlcable.NOTE:• When a remote control cable is connected to the REMOTEconnector, infrared remote control operations cannot beperformed.• Both the composite video signal from each input connectoras the computer, BNC, and BNC (CV), and the S-video signalfrom the BNC (Y/C) Input connector are not output from HDMIOUT Connector of this projector.[HDBaseT Models]• When [HDBaseT] is selected in the [REMOTE SENSOR]and the projector is connected to a commercially-availabletransmission device that supports HDBaseT, remote controloperations in infra-red cannot be carried out if transmissionof remote control signals has been set up in the transmissiondevice. However, remote control using infrared rays can becarried out when the power supply of the transmission deviceis switched off.* Connection Terminal ofMM ModelsThe orientation of theport is upside down.* Connection Termi-nal of HDBaseTModels
