674. Multi-Screen ProjectionProjecting two screens1. Press the MENU button to display the on-screen menu and select [DISPLAY] → [PIP/PICTURE BY PICTURE].This displays the [PIP/PICTURE BY PICTURE] screen in the on-screen menu.2. Select [SUB INPUT] using the ▼/▲ buttons, and press the ENTER button.This displays the [SUB INPUT] screen.3. Select the input signal using the ▼/▲ buttons, and press the ENTER button.* This screen belongs to a HDBaseT model.The [PIP] (PICTURE IN PICTURE) or [PICTURE BY PICTURE] screen set up under [MODE] is projected. (→page 101)• When the signal name is displayed in grey, this means that it cannot be selected.• The signal can also be selected by pressing the PIP button or PBP/POP button on the remote control.4. Press the MENU button.The on-screen menu will disappear.5. When returning to single screen, display the [PIP/PICTURE BY PICTUE] screen one more time and select[OFF] in the [SUB INPUT] screen of the Step 3.TIP:• During dual-screen projection, if the selected input is not supported by the sub-screen, the sub-screen will appear as a blackscreen.
