1656. Installation and Connections6. Place the lens shroud back onto the lens hood.• Tighten the two screws to fix the lens shroudNOTE :Be sure to perform [CALIBRATION] after installation or replacement ofthe lens. (→ page 17, 126)Removing the lensBefore removing the lens:1. Turn on the projector. (→ page 16)2. Press and hold the SHUTTER/HOME POSITION button for a minimum of 2 seconds.The lens position will return to the home position. (→ page 24)3. Turn off the main power and unplug the power cord.4. Wait for the projector to cool sufficiently before removing the lens.1. Remove the lens shroud.(→ page 163)2. Slowly turn the lens release lever clockwise until it pointsupward.3. Set the safety lever to the left position (UNLOCK).LOCKLOCKLENS4. Slowly remove the lens from the projector by pulling itstraight out.• After removing the lens, attach the lens cap to both thefront and back of the lens for proper storage.5. Place the lens shroud back into the lens hood.• Tighten the two screws to fix the lens shroud.• If the projector is stored without the lens, attach the dustcover to the lens hood.
