41. Introduction Part Names of the ProjectorFront/TopThe lens is sold separately. The description below is for when the NP27ZL lens is mounted.Control Panel(→ page 6)LensVentilation (inlet)Filter CoverHandleLens HoodSecurity Locking PinStacking ColumnLens ShroudRemote Sensor (located on thefront and the rear)(→ page 9)Terminal Panel(→ page 7)LED Lights (six locations)Indicator Section(→ page 6)Lens Release Lever/Safety Lever(both levers are located inside thelens shroud.)(→ page 163)AC InputConnect the supplied power cord'sthree-pin plug here, and plug theother end into an active wall outlet.(→ page 13)Main Power SwitchUSB (LAN) Port (for optional Wire-less LAN Unit) (→ page 174)Lens Cap(The lens cap is attached to thelens.)VOLTAGE SELECT SwitchUse this switch according to thevoltage being used.(→ page 13)Adjustable Tilt Foot(→ page 22)Slot for Power Cord Stopper (→page 14)
