2-12 Setup and OperationTo load a disc in the CD-ROM reader, follow these steps.1. Press the open/close/stop button. The CD tray opens.2. Put the CD, printed side up, into the tray.3. Press the open/close/stop button again and the tray closes.4. To remove the disc, press the open/close/stop button. The tray opens, allowingremoval of the disc.SYSTEM CONFIGURATIONThis section describes the Setup utility program that allows the system configurationinformation to be viewed and changed.NOTE: The system ships from the factory withthe correct system parameters for theconfiguration. Unless setting the time and date,setting security features, customizing the system,or adding optional hardware, Setup does notneed to be run.System configuration information is stored in nonvolatile memory. Nonvolatile memory inthe system is a complementary metal-oxide semiconductor (CMOS) chip backed by abattery, either a coin-type battery or a real-time clock/battery module on the system board.The battery supplies continuous power to the CMOS memory and maintains configurationinformation when system power is off.Setup UtilityThe Setup utility is used to view and set system parameters. Use the Setup utility to: set the time and date. update or check system parameters when adding or removing expansion options. change or set power management features. correct a hardware discrepancy when the Power-On-Self-Test (POST) displays anerror message and a prompt appears to run Setup. check the installation of optional memory by comparing the amount of memoryinstalled with the amount of memory displayed by Setup. change certain system operating parameters, such as boot device sequence orkeyboard parameters.
