Program20Program 20 : System Option Setup20-16 : Selectable Display MessagesLevelSADescriptionUse Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.There are 20 alphanumeric messages, with up to 24 characters. Use the following chart whenprogramming messages.When you want to . . .Use this keypad digit . . .1 Enter characters:2 Enter characters: A-C, a-c, 2.3 Enter characters: D-F, d-f, 3.4 Enter characters: G-I, g-i, 4.5 Enter characters: J-L, j-l, 5.6 Enter characters: M-O, m-o, 6.7 Enter characters: P-S, p-s, 7.8 Enter characters: T-V, t-v, 8.9 Enter characters: W-Z, w-z, 9.0 Enter characters:* Enter characters:# # = Accepts an entry (only required if two letters on the same key are needed - ex:TOM). Pressing # again = Space. (In system programming mode, use the rightarrow soft key instead to accept and/or add a space.)Clear/Back Clear the character entry one character at a time.Flash Clear all the entries from the point of the flashing cursor and to the right.When using DTP or DTU style telephones on the SL1000 system, not all the same characters areavailable.Input Data01~20Selectable Display Message NumberItem No. Input Data01 16 charactersDefaultNumber Message1 IN MEETING UNTIL ##:##2 MEETING ROOM - ########3 COME BACK ##:##4 PLEASE CALL ###########5 BUSY CALL AFTER ##:##Issue 0.1 SL1000Programming Manual 2-163
