Program44Program 44 : ARS/F-Route Setup44-05 : ARS/F-Route TableLevelINDescriptionUse Program 44-05 : ARS/F-Route Table to set the ARS/F-Route table. There are four kinds of order.If the higher priority trunk groups are busy, the next order group is used. If a lower priority route isselected, the caller may be notified with a beep tone.Input DataARS/F-Route Table Number 1~100Priority Number 1~4Item No. Item Input Data Default01 Trunk Group NumberSelect the trunk group number to use for the outgoingARS call.0 = No Setting1~25 = Trunk Group101-150 = Networking255 = Extension Call002 Delete DigitsEnter the number of digits to be deleted from the dialednumber.0~255(255 = Delete All)003 Additional Dial Number TableEnter the table number (defined in Program 44-06) foradditional digits to be dialed.0~100 004 Beep ToneSelect whether or not a beep is heard if a lower prioritytrunk group is used to dial out.0 = Off1 = On005 Gain Table Number for Internal CallsSelect the gain table number to use for the internal call(defined in Program 44-07).0~1000 = No Setting006 Gain Table Number for Tandem ConnectionsSelect the gain table number to use for the tandem call(defined in Program 44-07).0~1000 = No Setting007 ARS Class of ServiceSelect the ARS Class of Service to use for the table.An extension ARS COS is determined in Program26-04-01.0~16 008 Dial TreatmentSelect the Dial Treatment to use for the table. If a DialTreatment is selected, Programs 44-05-02 and44-05-03 are ignored and the Dial Treatment defined inProgram 26-03-01 is used instead.0~15 009 Maximum DigitInput the maximum number of digits to send whenusing the F-Route.0~24 010 CCIS over IP Destination Point CodeInput the Destination Point Code to send when usingthis F-Route.0~16367 011 Network Specified Parameter TableEnter a table number from Program 26-12.0~16 0ConditionsNoneFeature Cross Reference• Automatic Route Selection (ARS)Issue 0.1 SL1000Programming Manual 2-343
