Figure 2-147 Daisy-Chain LayoutFor detailed information on daisy-chain layout and configuration, contact your installer or refer to theDTL-RPT-1 Administrator's Guide.6.2.1 Setting Up Your RepeaterBefore installing the repeater, you must activate the repeater mode on your base and then register therepeater to the base and any handsets. Before you start the registration process, be sure you have:• A working base• A working handset registered to that base• Any repeaters you want to register to this base (you must complete the registration processseparately for each repeater)• At least one of the AC adapters supplied with the repeatersUse ONLY the power adapter that came with your repeater. A different power adapter may cause anelectrical hazard or damage the repeater.6.2.1.1 Changing the Telephone System PINBefore you start the registration process, you must reset the system PIN of your telephone to 0000(consult the manual that came with your base for more information). After you reset the PIN, makesure to register the handset you used back to the base station.6.2.1.2 Automatic RegistrationThe repeater seeks out the base with strongest DECT/GAP signal and automatically registers to thatbase.1. Make sure the repeater is powered off (i.e., the AC power adapter is not connected).2. Set the base in registration mode. (Consult the owner's manual that came with your base stationfor more information.3. Use the AC adapter to connect the repeater to a standard 120 V AC outlet. (Do not use a poweroutlet controlled by a wall switch.) The LED on the repeater flashes briefly, then remains on andsteady.If the LED continues to flash, register the repeater again.The repeater is now registered to this base and is ready to use.You can safely disconnect the power and move the repeater to the selected location; the repeaterstays registered to the base.ISSUE 5.0 SL1100Hardware Manual 2-99
