Selecting Paper and Media 6–11ITEMAcid contentAsh contentSingle-sheet feed*1Multi-sheet feed*2BrightnessCalliperFurnishCurlCut edge conditionElectrical surface resistivityElectrical volume resistivityFinishingFusing capabilitySPECIFICATION5.5 pH to 8.0 pH.Cannot exceed 10% or contain large amounts ofclay or talc.16 to 28 pound (60 to 105 g/m2).16 to 22 pound (60 to 82 g/m2 ).83% minimum.3.7 to 7.5 mils.100% chemical wood pulp with up to 25% cottonfiber recommended.Zero curl toward image side, minimum 15-inchradius curl toward opposite side.Sharp edges, no visible fray.2.0 to 15 × 1010 ohms/square (conditioned at 22˚C(71.6˚F) plus 50% relative humidity).1.2 to 15 × 1011 ohm × centimeter (conditioned at22˚C (71.6˚F) plus 50% relative humidity).Cut sheets must be within ±0.0313 inches ofnominal, corners at 90˚ ±0.2˚.Cannot scorch, melt, offset, or release emissionswhen heated to 200˚C (392˚F) for 0.1 second.*1 “Single-sheet Feed” refers to the method of placing print media in the hopperone sheet at a time.*2 “Multi-sheet Feed” refers to the method of placing print media in the hopperseveral sheets at a time for continuous feeding.Sheet Paper All sheet paper properties must match the paperspecifications listed in Table 6-1.Table 6-1 Paper Specifications
