Chapter 2 - Blade Installation and StartupChapter 2 2 - 332.4.5 VoIP (VOIPDB) Daughter Board (Figure 2-16 - Figure 2-16) - P/N 0911030, 0911032, 0911034The 32VOIPDB, 64VOIPDB and 128VOIPDB daughter boards are used for converting the RTP (Real TimeTransfer Protocol) packets via the IP network and PCM highway. The daughter board is installed on the CCPU.The IP terminals are connected directly to the IP bus. When IP terminals need to be connected to aconventional PCM-based digital circuit, this daughter board converts the IP packet signal into a PCM signalformat and connects to the PCM time division switch.The VOIPDB daughter board is required in order for IP terminals to communicate with non-VoIP UX5000terminals, as well as to place or receive outside calls.The VoIP daughter board provides the voice (RTP/RTCP) processing function. The call control function ismounted on the CCPU. Only one version of the VOIPDB (32, 64, or 128) can be installed on the CCPU at atime.The VOIPDB daughter board provides:● 32 (32VOIPDB), 64 (64VOIPDB) or 128 (128VOIPDB) channels● 64VOIPDB and 128VOIPDB Only: Layer 2 Switch● 64VOIPDB and 128VOIPDB Only: 10/100/1000 Gigabit Ethernet Connection● 64VOIPDB and 128VOIPDB Only: RTP/RTCP Packet Transmitted/Received Directly32VOIPDB: RTP and RTCP Packeted Transmitted/Received by Fast Ethernet LAN Interface on CCPU● 64VOIPDB and 128VOIPDB Only: 4 Blade Status LEDs● Support for CODECs: G722, G726, iLBCWhen installing a VoIP daughter board, the system will not allocate trunk ports for the daughter board. Thismust be defined in Program 10-40-02. Ports are allocated in groups of 4. For IP extensions, the system willonly allocate extension ports once an IP terminal is connected. At that time, the system will reserve a group of4 extension ports. Once the 4 ports are used, the system will then reserve another group of 4 when another IPextension is connected.2.4.5.1 LED IndicationsLED Function LEDStatus Operation StatusACT (LED 1) Link activity or datatransmission and reception.On Green Link up completedFlashing Data being transmitted/received.LINK10_100(LED2)10Base-T/100Base-TX linkspeed indicator.On Red 100Base-TX link upWhen:LED 1=OnLED 2= OffLED 3=OffLink up 10Base-TLINK1000(LED3)1000Base-T link speedindicatorOn Red 1000Base-T link upDUPLEX(LED4)Duplex Status On Yellow Full duplex operation
