Chapter 2 - Blade Installation and StartupChapter 2 2 - 912.9.3.1 Entering the Programming ModeEnter the system programming mode at extension 301:1. Press CALL1. (You hear dial tone).2. Dial # * # *.3. Dial the system password.4. Press HOLD.2.9.3.1 Port DefaultsWith the default settings, the ports are assigned as follows:In the initial configuration:● All Programmable Function keys are line keys (e.g., key 1 is line 1).● All trunks are loop start DTMF.2.9.4 Setting Up Extension Circuit TypesUse Program 10-03 to set up extension circuit types as required. The system will automatically detect andassign most circuit types when the device is connected. Refer to the Software Manual for programminginformation.1. Enter 10-03-01.2. Select the slot, port or channel (with ESIU blades) to be programmed.3. Set the terminal type or option as needed.● Refer to the Software Manual for this information.● If the system has DSS Consoles, Program 30-02 must be used to define DSS extensionassignments.Password Level12345678 2 (IN)0000 3 (SA)9999 4 (SB)Station Ports: 1-512 (extensions 301-499 and 5000-5312)Virtual Station Ports: 1-256 (extensions not assigned)Trunk Ports: 1-200
