Chapter 4 - Terminals and Optional EquipmentChapter 4 4 - 694.17.3 Programming the IP Terminal for the 911 Dialing When Lock Feature ActivatedThe Lock button on the IP terminals will provide a user with the ability to prevent calls on their terminal whileaway from their desk. This will prevent all calls from being dialed - including 911. In order to allow anyone todial 911 from a locked IP terminal, each terminal must be set up to override the lock function. Each IP terminalcan have up to 3 emergency numbers defined which can be dialed when a terminal is locked. Perform thefollowing steps on any IP terminal which may be used to dial an emergency number.1. Enter the terminal’s program mode by pressing HOLD CONF * #.2. At the log-in screen, enter the user name (default: ADMIN) and password (default: 6633222) and pressthe OK Soft Key.3. Press Soft Key 6 for “Application Setting”.4. Press Soft Key 5 for “Emergency Call”.5. Press Soft Key 1, 2 or 3 for the emergency number entry.6. Dial the emergency number to be allowed (ex: 911).7. Press Soft Key 4 for “OK” to complete.8. Continue pressing Soft Key 4 to exit (Exit-Exit-Save). The terminal will reset automatically.4.17.4 Using the Lock Feature on IP-CTS or Enhanced TerminalsThe Lock button on the IP-CTS or IP Enhanced terminals will provide a user with the ability to prevent calls ontheir terminal while away from their desk. This will prevent all calls from being dialed - including 911 (unlessallowed by changing the terminal’s setup (as defined above).1. Press the LOCK button at the top of the IP-CTS or IP Enhanced terminal.2. The screen displays “Security Lock?”. Press the OK Soft Key to enable or CANCEL to exit without settingthe feature.● The screen displays a screen saving while locked and the Lock LED will be lit.3. To clear the Lock feature, press any key. The screen request the password entry. Dial the 4-digitpassword for the terminal and press the OK Soft Key.● The terminal returns to an idle condition. If required, the UX5000 administrator can resetthe terminal if a password is forgotten.! Important !Once a locked terminal is used to dial an emergency number, the terminal will beunlocked until the Lock button is pressed again.
