NEC Univerge SV8100 Features And Specifications Manual

Also see for Univerge SV8100: User guide User guide User guide User guide Quick reference guide

Contents

NEC Univerge SV8100 Features And Specifications Manual Manual pdf 267 page image

UNIVERGE SV8100 Issue 12.0Caller ID 2 - 237Caller IDDescriptionCaller ID allows a display terminal to show an incoming caller’s telephone number (called the DirectoryNumber or DN) and optional name. The Caller ID information is available as pre-answer display. Withthe pre-answer display, the user previews the caller’s number before picking up the ringing line. On the CD-CP00-US for Caller ID (also used for DTMF receivers and Call Progress Tone Detection) 32 resources areavailable. The PZ-BS10 provides an additional 64 resources.Second Call DisplayWhile busy on a call, the telephone display can show the identity of an incoming trunk or Intercom call.For incoming trunk calls, the display shows the Caller ID or ANI data or the trunk name if Caller ID or ANIare not installed. (Refer to T1 Trunking (with ANI/DNIS Compatibility) on page 2-1561 for moreinformation on ANI compatibility.) For incoming Intercom calls, the display shows the calling extensionname.Caller ID supports the Telco Called Number Identification (CNI) and Called Number Delivery (CND)service, when available. These services provide the Caller ID information (i.e., messages) between thefirst and second ring burst of an incoming call. Two types of Caller ID message formats are currentlyavailable: Single Message Format and Multiple Message Format. With Single Message Format, theTelco sends only the caller’s telephone number (DN). The DN has seven or 10 digits. In MultipleMessage Format, the Telco sends the DN and the caller’s name. The DN for this format also has sevenor 10 digits, and the name provided consists of up to 15 ASCII characters.EnhancementsPressing the Left Cursor Key twice (on equipped terminals) displays the Incoming Call History(Version 3000 or higher software).With Version 4000 (4.01 or higher) software, calls to a busy extension or busy tones returned to thecaller are logged in the Caller ID List. When a busy call is logged, the Caller ID List key flashes thesame as it does with a new missed call.Memo Display FunctionWith Version 4000 or lower software, the SV8100 can display matching Caller ID but is limited to 12characters. With Version 5000 or higher software, it can display up to 28 Characters per line and upto three lines of information for a total of 84 characters (Maximum 28 digits x 3 lines). If needed, thesystem can be set to use any one of three available display lines. Additionally, the original CIDinformation can be seen while on the call by pressing the right cursor button on the phone. The MemoDisplay Function requires Version 5000 or higher software and the Version 5000 Enhancementlicense.