E–11Terminal Panel Features1. RGB Input Connector(Mini D-Sub 15 pin)Connect your PC or other RGB equipment. Use the suppliedsignal cable to connect to a PC.2. RGB Monitor Output Connector (Mini D-Sub 15 pin)You can use this connector to loop your computer image to anexternal monitor from the RGB input source.3. Audio Input (Mini Jack)This is where you connect audio output from your computer.4. Audio Input (RCA)This is where you connect audio output from a VCR, DVDplayer, or laser disc player.5.Audio Output (Mini Jack)Connect audio equipment to this jack. Note that this cannot beused as a headphone jack.(When audio equipment is connected, the projector speaker isdisabled.)When a cable mini-plug is inserted into this jack, both theright and left audio signals are not mixed, but separate.For example, when a cable mini-plug is inserted into the leftAUDIO IN jack only, only left sound is output.NOTE1: ON AUDIO IN/OUTThe audio input (mini jack) 3 is available for RGB source only.The audio input (RCA) 4 is available for Video or S-Video sourceonly.The audio output (mini jack) 5 operates when audio source 3 or4 is selected.NOTE2: During Stand by ConditionRGB signal will be sent to the connected external monitor. Audiosignal will not be sent to the audio output.6. Video Input (RCA)Connect a VCR, DVD player, laser disc player, or documentcamera here to project video.7. S-Video Input Port (Mini DIN 4 Pin)Connect the S-Video input from an external source like a VCR.8. PC Control Port (Mini DIN 8 Pin)Use this port to connect your PC to control your projector.This enables you to use your PC and serial communicationprotocol to control the projector. If you are writing your ownprogram, typical PC control codes are on page E-45.AC INSOURCEAUTO ADJUSTSTATUSPOWEREMNUCNACELTERNESELECTCONTROLAC INON STAND BYPCINOUTININL/MONORININRGB OUTRGB INAUDIOINOUTS-VIDEOVIDEOININL/MONORININRGB OUTRGB IN64 5 2 873 1CONTROLPC