NTI ENTERPRISE ENVIRONMENT MONITORING SYSTEM27USE AND OPERATION VIA WEB INTERFACEA user may monitor and configure the settings of any device connected to the ENVIROMUX using the Web Interface via any webbrowser (see page 4 for supported web browsers). To enable the Web Interface, connect the ENVIROMUX to the Ethernet(page 15). Use the Device Discovery Tool (page 26) to setup the network settings. Then, to access the web interface controls,the user must log in.Note: In order to view all of the graphics in the Web Interface, the browser’s JavaScript and Java must be enabled.Log In and Enter PasswordTo access the web interface, type the current IP address into the address bar of the web browser. (The default IP address for theENIVROMUX is shown below):Note: If an ENVIROMUX-3GU USB modem is installed (page 16) and configured to enable access to the web interfacethrough it (page 62), you can instead enter the IP address of the SIM card account (requires ENVIROMUX-xD firmwareversion 2.5 or later.) If the ENVIROMUX is properly configured, you can view the SIM card IP address on the systeminformation page (page 73).A log in prompt requiring a username and password will appear:Username = rootPassword = nti(lower case letters only)Note: usernames and passwordsare case sensitiveFigure 26- Login prompt to access web interfaceWith a successful log in, a screen similar to the following will appear:Figure 27- Summary pagehttp://192.168.1.21
