Nanni T4.230 Operator's Manual
Also see for T4.230: Operator's manualOperator's manual
                                                                    | |
Contents
| 
To bleed the fuel system IF IT ISFITTED WITH AN ADDITIONALELECTRIC FUEL FEED PUMP :1. Fill totally the fuel tank. Openthe fuel cock.2. Loose the venting screw. Use rags around the ventingscrew.3. Start the engine for 5 to 10 sec-onds to let the electric fuel feedpump bring fuel to the injectionpump.4. Pump the fuel using the leveruntil fuel free of air bubblesflows from the venting screw.5. Continue pumping and at thesame time tighten the ventingscrew.6. Pump few other times to primethe system.I CAUTIONAvoid draining all fuel in the filterLubricationsystemI CAUTIONNever over-fill the engine oilcrankcase.NOTICE: With a new or recon-ditioned engine, oil and oil filtersmust be changed after 20 hours ofoperation. Use oil grades qualityindicated in the chapter TECHNI-CAL DATA. Warranty claims maybe rejected if unsuitable oil gradehas been used.The viscosity may be adapted de-pending the climatic conditions.Oil level- Addingengine oilCheck the engine and transmissionoil level before starting the engine.Always make sure that the level isin the safe range.The oil level should be within therange indicated on the dipstick,between the Mini and Max level. Tocheck the oil level:1. Remove and wipe the dipstick.2. Re-insert and remove thedipstick.3. Check that the oil level is be-tween the Mini and Max mark.40 |
Related manuals for Nanni T4.230
manualsdatabase
Your AI-powered manual search engine