Nanni T4.230 Operator's Manual
Also see for T4.230: Operator's manualOperator's manual
                                                                    | |
Contents
| 
If the level is too low, remove the oilfiller plug and add oil slowly. Waitfew minutes before checking the oillevel to let the oil drain down to theoil pan.NOTICE: Completely drain the pre-vious oil before adding new engineoil. Never mix different type of oil.Draining the engine oil1. Start the engine and let it warmfew minutes so that oil suction iseasier.2. Stop the engine and removethe key from the panel.3. Remove the cap of the drainpipe and connect the oil drainpump.4. Drain all the oil in the oil pan.5. Disconnect the oil drain pumpand replace the cap on the drainpipe.Changing the oil filterChange the oil filter each time theengine oil is drained.1. Remove the oil filter with a filterwrench. Turn the filter counter-clockwise. Remove the gasket.2. Clean the mating surface inorder to prevent impurities fromentering the engine.3. Apply a film of oil on the newgasket. Screw the new filter byhand with the new gasket. Whenthe gasket contacts the matingsurface, turn the filter a half turn.4. Fill with correct amount of newoil. Check for leaks and check theoil level.5. Start the engine and let it oper-ate few minutes at idle. Checkthat the oil pressure warning lampgoes out.6. Stop the engine, wait for the en-gine to cool down and check theoil level. Top up if necessary.41 |
Related manuals for Nanni T4.230
manualsdatabase
Your AI-powered manual search engine