Napoleon Luxuria series Installation Manual

Also see for Luxuria Series: Owner's manual Owner's manual Installation manual Owner's manual

Contents

Napoleon Luxuria series Installation Manual Manual pdf 29 page image

ENW415-1710 / B / 08.17.1829installation planning4.3 installation option 3 - Rear OpeningAir outlet opening is required to be centered with the appliance.(Q x R)* AIR OUTLETOPENING IS HOTWHEN APPLIANCEIS OPERATING!Room 1Room 2Dynamic HeatControl™ rearair outlet openingmust be locatedout of reach ofthe user. Openingmust not be re-stricted by furnish-ings or decor.Minimum air outlet opening dimension must be followed. The opening is required to be framed no more than 1.5” below theenclosure top (see option 3 diagram) to avoid trapping heat in the upper areas and centered on the appliance center. Framingthe rear opening lower will overheat the appliance, the enclosure, and finishing material.SWall mountedobject (pictureframe,appliance, etc.)AccessSide offireplaceOtherroomceilingenclosure topmust be installed 2-3”0-1.5” Max6” minALTERNATIVE2 1/2”minIncreasing the air outlet opening will allow the appliance, the glass barrier, the temperatures on the surfaces above the fireplace open-ing, and the enclosure be at cooler temperatures. It will also allow the air to circulate more effectively in the room. However, if the ap-pliance is equipped with the Dynamic Heat Control™ Plus, then the opening size must be 80 sq. in. for models LVX38 andLVX50, or 160 sq. in. for models LVX62 and LVX74.note:Suitable for Dynamic Heat Control™ PlusSuitable for Dynamic Linear Trim! WARNING• When using a rear (or two-sided) air out-let opening, it is critical that the adjoin-ing room or living spaces are in directair communication (i.e. of an open planconfiguration or connected by a perma-nently open doorway or archway). Thisprevents the appliance from being in anegative pressure more than that of theadjoining room. Failure to follow theserequirements can result in reversing theDynamic Heat Control™ air flow andwill cause the appliance, glass guardassembly, and finishing materials tooverheat, creating a fire hazard.