Napoleon Luxuria series Installation Manual

Also see for Luxuria Series: Owner's manual Owner's manual Installation manual Owner's manual

Contents

Napoleon Luxuria series Installation Manual Manual pdf 33 page image

ENW415-1710 / B / 08.17.1833rough framing - before appliance installationminimum clearance5.1.1 minimum clearance to combustible enclosuressingle-sided6” [152mm] minimum(inside enclosure)0” to back standoffs0” to bottom of theappliance0” to side standoffsWhen passing through a ceiling,use firestop spacer W500-0028(not supplied)1” [25mm] minimum all sides forsections of vertical venting.1/2” finishing flange3” [76mm] to top(outside of enclosure)2” [51mm] to sides /bottom(outside of enclosure)When passing througha wall, use firestopspacer assemblyW010-4178 (supplied)0” to non-combustiblefinishing such as brickand stone. When usingnon-combustible finish-ing, only use firestopspacer (W615-0162)included in the firestopassembly (W010-4178)LRef LVX38 LVX50 LVX62 LVX74L 73” (185.4cm) 73” (185.4cm) 91” (231.1cm) 91” (231.1cm)Horizontal vent sections: A minimum clearance of 3” (76mm) on the top outside of the enclosure and 2” (51mm) onthe sides and bottom outside of the enclosure all around the vent pipe on all horizontal runs to combustibles is required.Horizontal vent sections within enclosures require a minimum clearance of 6”(152mm) at the top of the vent pipe.Vertical vent sections: A minimum of 1” (25mm) all around the vent pipe on all vertical runs to combustibles is requiredexcept for clearances in appliances enclosures. Vertical vent sections within enclosures require a minimum clearance of1” (25mm) around the vent pipe.The LVX series requires a minimum enclosure height, as illustrated (dimension L), measured from the bottom of the appli-ance. For temperature requirements, this area must be left unobstructed. Some venting configurations that require morevertical rise will require a larger enclosure to provide minimum vertical clearance between vent pipes and combustibles.note: