Napoleon Luxuria series Installation Manual

Also see for Luxuria Series: Owner's manual Owner's manual Installation manual Owner's manual

Contents

Napoleon Luxuria series Installation Manual Manual pdf 49 page image

ENW415-1710 / B / 08.17.1849electrical informationAfter installing the electrical wiring and gas lines, ensure to test the appliance before finishing theframing and finishing the appliance.8.0 gas installation21.1! WARNING• Risk of fire, explosion, or asphyxiation. Ensure there are no ignition sources such as sparks or open flames.• Support gas control when attaching gas supply pipe to prevent damaging gas line.• Always light the pilot whether for the first time or if the gas supply has run out with the glass door openedor removed. Purging of the gas supply line should be performed by a qualified service technician. Ensurethat a continuous gas flow is at the burner before closing the door. Ensure adequate ventilation. For gas andelectrical locations, see “dimensions” section.• All gas connections must be contained within the appliance when complete (gas fi replaces only).• High pressure will damage valve. Disconnect gas supply piping before testing gas line at test pressures above1/2 PSIG.• Valve settings have been factory set, do not change.Installation and servicing to be done by a qualified installer.• Move the appliance into position and secure.• If equipped with a flex connector, the appliance is designed to accept a 1/2” (13mm) gas supply. Without theconnector, it is designed to accept a 3/8” (9.5mm) gas supply. The appliance is equipped with a manual shutoff valve to turn off the gas supply to the appliance.• Connect the gas supply in accordance to local codes. In the absence of local codes, install to the currentCAN/CSA-B149.1 Installation Code in Canada or to the current National Fuel Gas Code, ANSI Z223.1 / NFPA54 in the United States.• When fl exing any gas line, support the gas valve so that the lines are not bent or kinked.• The gas line flex-connector should be installed to provide sufficient movement for shifting the burner assemblyon its side to aid with servicing components.• Check for gas leaks by brushing on a soap and water solution. Do not use open flame.Connect the gas supply to the 1/2” (13mm) shut off and flex connector (supplied). Ensure gas supply issecured.note:Before finishing in the appliance test the operation using the remote control, cycling it through all of its differentmodes, see “operation” section in the Owner’s manual. Should troubleshooting be required, access to the controlscan be made through the pre-finishing access panel. All other functions, excluding the burner operation, will notoperate during the event of a power failure.