© National Instruments | 1-15RMX Programmable Power Supplies User ManualAttaching the Output Terminal CoverYou can adjust the diameter of the holes that the load cables pass through by changing thepositions in which the top and bottom halves of the OUTPUT terminal cover are put together.There are two available positions. Use the appropriate position for the load cables that you are using.• For cables that are up to 10 mm in diameter: Put the top and bottom halves of the OUTPUTterminal cover together so that the hole diameter is small.• For cables that are between 10 mm and 18 mm in diameter: Put the top and bottom halvesof the OUTPUT terminal cover together so that the hole diameter is large.1. Remove the screw that is attached next to the output terminals on the RMX. Use this screwto attach the OUTPUT terminal cover.2. Place the bottom half of the OUTPUT terminal cover underneath the load cables connectedto the output terminals.Figure 1-14. Attaching Bottom Half of the OUTPUT Terminal CoverNote The top and bottom halves of the OUTPUT terminal cover have differentshapes.3. Align the tabs of the top half of the OUTPUT terminal cover with those of the bottom half.Align the tabs of the OUTPUT terminal cover according to the load cable diameter.Remove the screws, and thenline up the half of the cover.
