© National Instruments | 2-33RMX Programmable Power Supplies User ManualCF21 Command Language ParameterSelects the command language that is used in remote control messages. For the LAN interfaceto function, this parameter must be set to "SCPi."This parameter is applied when you turn the POWER switch off and on.CF22 Emulation Parameter During Remote ControlSelects the emulation that is used during remote control. If you have set the command languageto legacy languages, you can only select “GEn” or “PAG.”This parameter is applied when you turn the POWER switch off and on.CF23 SCPI Communication Error Display ParameterSelects whether to display communication errors. The errors are only displayed when you areusing the SCPI language.Value Parameter DescriptionSCPi The SCPi language will be used (factory default setting).LGCy Legacy languages will be used.Value Parameter DescriptionnonE Remote control is performed using the RMX programmablepower supply’s commands made by National Instruments(factory default setting).5700 Remote control is performed using the N5700/N8700 commandsmade by Agilent Technologies.GEn Remote control is performed using the Genesys series commandsmade by TDKLambda.PAG Remote control is performed using the PAG series commandsmade by Kikusui.dCS Remote control is performed using the DCS series commandsmade by Sorensen.Value Parameter DescriptionoFF SCPI communication errors are not displayed (factory defaultsetting).on SCPI communication errors are displayed.
