Nidec Digitax HD M753 User Manual

Also see for Digitax HD M753 EtherCAT: Installation and technical guide

Contents

Nidec Digitax HD M753 User Manual Manual pdf 130 page image

SafetyinformationProductinformationMechanicalinstallationElectricalinstallationGettingstartedBasicparametersRunningthe motor Optimization EtherCATinterfaceSD CardOperationOnboardPLCAdvancedparameters Diagnostics UL listinginformation130 Digitax HD M753 Control User GuideIssue Number: 310 SD Card Operation10.1 IntroductionThe Non-Volatile Media Card feature enables simple configuration ofparameters, parameter back-up, storing / reading PLC programs anddrive copying using an SD card storing / reading PLC programs.The SD Card can be used for:• Parameter copying between drives• Saving drive parameter sets• Saving an onboard user programThe SC Card slot is located at the middle of the module, adjacent to thedrive compact display (if installed) on the right-hand side.Ensure the SD Card is inserted with the contacts facing the left-handside of the drive.The drive only communicates with the SD Card when commanded toread or write, meaning the card may be "hot swapped".Figure 10-1 Installation of the SD Card1. Installing the SD Card2. SD Card installed10.2 SD Card supportThe SD Card can be used to store drive parameter sets and / or PLCprograms set from the Digitax HD in data blocks 001 to 499 on the card.If the read only flag is set then only codes 6yyy or 9777 are effective.Figure 10-2 Basic SD Card operationThe whole card may be protected from writing or erasing by setting theread-only flag as detailed section 10.3.9 9888 / 9777 - Setting andclearing the SD Card read only flag on page 132.The card should not be removed during data transfer, as the drive willproduce a trip. If this occurs then either the transfer should bereattempted or in the case of a card to drive transfer, default parametersshould be loaded.Beware of possible live terminals when installing theSD Card.WARNING12NOTENOTEBootDrive reads allparameters fromthe SD CardPr 00.030 = Read +Programs all driveparameters to theSD CardOverwrites anydata already indata block 1Pr 00.030 = Program +Drive automaticallywrites to the SD Cardwhen a parametersave is performedAutoSavePr 00.030 = Auto +AutoSaveDrive boots from theSD Card on powerupand automaticallywrites to the SD Cardwhen a parametersave is performedPr 00.030 = Boot +