SafetyinformationProductinformationMechanicalinstallationElectricalinstallationGettingstartedBasicparametersRunningthe motor Optimization EtherCATinterfaceSD CardOperationOnboardPLCAdvancedparameters Diagnostics UL listinginformationDigitax HD M753 Control User Guide 135Issue Number: 30 - Stop the User ProgramThe onboard user program is stopped. If it is restarted by settingOnboard User Program: Enable (11.047) to a non-zero value thebackground task starts from the beginning.1 - Run the User ProgramThe user program will execute.This parameter is read-only and indicates the status of the user programin the drive. The user program writes the value to this parameter.0: Stopped1: Running2: Exception3: No user program presentThis parameter holds the number of times an Onboard PLC userprogram download has taken place and is 0 on dispatch from the factory.The drive is rated for one hundred program downloads. This parameteris not altered when defaults are loaded.This parameter shows the number of times the freewheeling task hasstarted per second.This parameter shows the percentage of the available time used by theuser program clock task.This parameter shows the interval at which the clock task is scheduled torun at in ms.11.5 Onboard PLC tripsIf the drive detects an error in the user program it will initiate a UserProgram trip. The sub-trip number for the User Program trip details thereason for the error. See Chapter 13 Diagnostics on page 222 for moreinformation on the User Program trip.11.048 Onboard User Program: StatusRO Txt NC PT -2147483648 to2147483647 11.049 Onboard User Program: Programming EventsRO Uni NC PT PS 0 to 65535 11.050 Onboard User Program: Freewheeling Tasks PerSecondRO Uni NC PT 0 to 65535 11.051 Onboard User Program: Clock Task Time UsedRO NC PT 0.0 to 100.0 % 11.055 Onboard User Program: Clock Task ScheduledIntervalRO NC PT 0 to 262128 ms
