136Caring for the CameraTechnical NotesCleaningDo not use alcohol, thinner, or other volatile chemicals.LensAvoid touching glass parts with your fingers. Remove dust or lint with a blower(typically a small device with a rubber bulb attached to one end that ispumped to produce a stream of air out the other end). To remove fingerprintsor other stains that cannot be removed with a blower, wipe the lens with a softcloth, using a spiral motion that starts at the center of the lens and workingtoward the edges. If this fails, clean the lens using a cloth lightly dampenedwith commercial lens cleaner.Monitor Remove dust or lint with a blower. To remove fingerprints and other stains,clean the monitor with a soft, dry cloth, being careful not to apply pressure.BodyUse a blower to remove dust, dirt or sand, then wipe gently with a soft, drycloth. After using the camera at the beach or seaside, wipe off any sand or saltwith a dry cloth lightly dampened with fresh water, then dry thoroughly. Notethat foreign matter inside the camera could cause damage not covered by thewarranty.
