General Information28Service Manual
SC6500™d. Inspect the Solution Tank Drain Hose, Recovery Tank Drain Hose and Vacuum Hose for wear or damage.Replace the if kinked or damaged.5. Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.6. Remove the squeegee, rinse it with warm water, then reinstall.7. Remove the Hopper on cylindrical systems and clean thoroughly. You can remove the Hopper from eitherside of the machine by removing the side skirt, tilting the Hopper up and away from housing, thenpulling the Hopper out.8. Check the following maintenance schedule and perform any required maintenance before you store themachine.Maintenance ScheduleMaintenance Item Daily Weekly Monthly YearlyCharge Batteries XCheck/Clean Tanks and Hoses XCheck/Clean/Rotate the Brushes/Pads XCheck/Clean the Squeegee XCheck/Clean Vacuum Shutoff Float XCheck/Clean the Vacuum Motor Foam Filter(s) XClean Hopper on Cylindrical System XCheck the Water Level in each Battery Cell XInspect Scrub Housing Skirts XInspect and Clean Solution Filter XCheck Foot/Parking Brake For Wear and Adjustment XClean Solution Dispensing Trough on Cylindrical System XPurge Detergent System XSide Broom Maintenance XLubrication - Grease Fittings X* Check Carbon Brushes X* Inspect the vacuum motor carbon brushes every 300 operating hours. Check the brush and drive motorcarbon brushes every 500 operating hours.Note: Refer to the individual machine sections in this manual for more detail on maintenance andservice repairs.9. Store the machine indoors in a clean, dry place. Keep the machine from freezing. Leave the tanks opento air them out.10. Turn the key switch off (O) and remove the key.Caution! Do not pressure-wash the operator control panel, circuit breaker panel or anyelectrical areas of the machine.