13TOLL FREE: 1- 877- 646- 5288HOW TO CLEANCAUTION: Make sure that the motor base is unpluggedfrom the power source before inserting or removing anyattachment and before cleaning.CAUTION: DO NOT immerse the motor base into wateror any other liquid.1 Separate/remove all parts from each other.2 Clean the motor base and dough station with a dampcloth and wipe dry.WARNING: DO NOT put the dough station in thedishwasher.3 Place the pitcher, single serve cup and bowl in thedishwasher. Place the lids and attachments on thetop rack. Use caution when handling the bladeassemblies as the blades are very sharp.NOTE: You may also wash the containers by filling ¾of the container with warm water and a drop of dishwashing detergent, placing the corresponding lid on thecontainer and pressing the pulse button a few times.Once clean, remove the container from the motor base.Rinse the container, attachment and lid under runningwater. Allow all the parts to dry before storing.Please call customer service if any servicing needs to beperformed on the appliance at 1-877-646-5288.Care & MaintenanceHOW TO STORE1 Store the Ninja® Kitchen System upright with thepitcher on the motor base, 6-Blade assembly inside thepitcher and lid on the pitcher. Do not place anything ontop. Store the bowl with the 4-Blade assembly insideand the lid on top. Store the single serve cup and therest of the attachments along side the appliance orin a cabinet where they will not be damaged andwon’t cause a hazard.2 Tuck power cord in cord storage compartment in theback of the motor base.RESETTING THE MOTOR THERMOSTATThe Ninja® Kitchen System features a unique safetysystem which prevents damage to the unit’s motorand drive system should you inadvertently overloadyour appliance. If the appliance is being overloaded,the motor will stop and the power light will remain litand speeds 1, 2 and 3 will flash. To reset the appliance,follow the resetting procedure below:1 Unplug the appliance from the electrical outlet.2 Remove and empty the container and ensurethat no food is jamming the cutting blades orattachments.3 Allow the appliance to cool for approximately 15minutes.4 Re-install the container onto the base and re-plugthe appliance into the electrical outlet.5 Proceed to use the appliance as before makingsure not to exceed the recommended maximumcapacities.Cord StorageBL660W_30_IB_ENG_120130_1.indd 13 12-01-30 1:57 PM