Nivus osm-f Operation Instruction Manual

Contents

Nivus osm-f Operation Instruction Manual Manual pdf 17 page image

Instruction ManualOCM FOCM F - Rev. 04 as of 18.02.2014 Page 176 Storing, Delivery and Transport6.1 ReceiptPlease check your delivery if it is complete and in working order according tothe delivery note immediately after receipt. Any damage resulting from transportor transit shall be reported to the carrier instantly. An immediate, written reportmust be sent to NIVUS GmbH Eppingen as well.Please report any shortcoming due to delivery to your representative or directlyto NIVUS Eppingen within two weeks in writing.Mistakes cannot be rectified later!6.2 DeliveryThe standard delivery of the OCM F measurement transmitter contains:− the instruction manual with the certificate of conformity. All required steps tocorrectly install and to operate the measurement system are listed herein.− a OCM F transmitter− a screwdriver with a 2.5 mm (0.098 in) blade for connecting the sensor insidethe terminal clamp housingAdditional accessories such as sensors, pressure compensation element (incase of using sensors, type “KDA” with integrated pressure measurement cellcombi sensor), overvoltage protection, separate level measurements etc. de-pending on order. Please check by using the delivery note.6.3 StoringThe following storing conditions must be strictly adhered to:Transmitter: min. temperature: - 30 °C (-22 °F)max. temperature: + 70 °C (158 °F)max. humidity: 80 %, non-condensingKDA-Sensor: min. temperature: - 30 °C (-22 °F)max. temperature: + 70 °C (158 °F)max. humidity: 100 %The devices must be protected from corrosive or organic solvent vapours, radio-active radiation as well as strong electromagnetic radiation.