Nivus osm-f Operation Instruction Manual

Contents

Nivus osm-f Operation Instruction Manual Manual pdf 36 page image

Instruction ManualOCM FPage 36 OCM F - Rev. 04 as of 18.02.2014®8 Initial start-up8.1 Notes to the UserFor proper start-up of the entire system it might be necessary to additionallyrefer to the accessories manuals below.>Installation instructions for Correlation and Doppler sensors<>Technical instructions for Doppler sensors<These manuals are part of the accessories standard delivery.Before you connect and operate the OCM F you should strictly follow the notesbelow!This instruction manual contains all necessary information to program and tooperate the device, addressing qualified technical staff who have appropriateknowledge about measurement technology, automation technology, informationtechnology and waste water hydraulics.To ensure a correct function of the OCM F this instruction manual must be readthoroughly!It is vital to read and comply with the safety instructions!The OCM F must be wired in accordance with the wiring diagram, see Fig. 7-3!If any problems regarding installation, connection or programming should occurplease contact our technical division or our service centre.NIVUS GmbHService hotline, Phone +49 (0)7262 9191-888or by e-Mail to: Hotline-worldwide@nivus.comFor initial start-up of the complete system, the instruction manuals of the acces-sories have also to be read. These manuals are included in the accessories de-livery.8.2 General PrinciplesThe initial start-up is not allowed until the installation has been finished andchecked. To exclude faulty programming this instruction manual must be readbefore the initial start-up. Please get familiar with the OCM F programming viadisplay and keyboard by, reading the instruction manual before you begin toprogram the device.After transmitter and sensors are connected (see chapters 7.4.1 and 7.4.2) theparameters must be set.