Instruction ManualOCM FOCM F - Rev. 04 as of 18.02.2014 Page 579.4.6 Parameter Menu “Analog Outputs“Fig. 9-36 Menü AnalogausgangInnerhalb dieses Menüs kann zwischen den Analogausgängen 1-3 mit den Pfeil-tasten >rechts< oder >links< gewählt werden.Function The selected analog output is going to be assigned to a function.Select from various functions:- Not active (no analog signal output)- Flow rate (output of analog signal which is proportional to calculated flowvolume)- Level (output of analog signal which is proportional to measured filling level)- Velocity (output of analog signal which is proportional to mean flow velocityaveraged from measured individual velocities)- Temperature (output of measured water temperature as analog signal)- Constant current (calculates from the ratio between valid readings to totalreadings resulting from velocity measurement, output as analog signal). Thisfunction is not conceived for control purposes, but for monitoring, remoteanalysis and for determination of sensor cleaning intervals.1 Analog output2 Start measurement3 Stop measurement (obstruction, standing water or no water etc.)Fig. 9-37 Analog output signal qualityThe Fig. 9-37 signal quality shows the analog output signal if the signal qualityhas been programmed. The signal will steeply rise at the beginning of the meas-urement (2).The signal is damped in order to avoid heavy signal fluctuation.
