— Adjust light sensitivity (images only). Increase the lightsensitivity in low light conditions to avoid too dark imagesand blurry images. Increasing the light sensitivity may alsoincrease the image noise.— Adjust contrast (images only). Adjust the differencebetween the lightest and darkest parts of the image.— Adjust sharpness (images only)The screen display changes to match the settings you define.The capture settings are shooting-mode specific. Switchingbetween the modes does not reset the defined settings.If you select a new scene, the capture settings are replacedby the selected scene. You can change the capture settingsafter selecting a scene if needed. .Saving the captured image may take longer if you change thezoom, lighting, or colour settings.Capture imagesWhen capturing an image, note the following:● Use both hands to keep the camera still.● The quality of a digitally zoomed image is lower than thatof a nonzoomed image.● The camera goes into battery saving mode if there are noactions for about a minute. To continue capturing images,slide the lock switch on the side of the device.To capture an image:1. To switch from video mode to image mode, if necessary,select and the image mode.2. To lock the focus on an object, press the capture keyhalfway down (not available in landscape or sport scenemodes). A green locked focus indicator appears on thedisplay. If the focus was not locked, a yellow focusindicator appears. Release the capture key, and press ithalfway down again. You can also capture an imagewithout locking the focus.3. To capture an image, press the capture key. Do not movethe device before the image is saved and the final imageappears on the screen.To zoom in or out when capturing an image, use the zoomkey in your device.To leave the camera open in the background and use otherapplications, press the menu key. To return to the camera,press and hold the capture key.After capturing an imageAfter you capture an image, select from the following options(available only if Show captured image is enabled in the stillimage camera settings):● Send — Send the image in a multimedia message, e-mail, or through connection methods such as Bluetoothconnectivity.To send the image to a person you are talking to, selectSend to caller) during a call.● Delete — Delete the image.● — Open GalleryCamera© 2008 Nokia. All rights reserved. 57