● Proxy port number — Enter the port number of the proxyserver.WLAN internet access pointsSelect Menu > Settings and Connectivity >Destinations > Access point, and follow the instructionson the screen.To edit a wireless LAN (WLAN) access point, open one of theaccess point groups and select an access point marked with.Follow the instructions from your WLAN service provider.● WLAN network name — Select Enter manually orSearch for networks. If you select an existing network,WLAN network mode and WLAN security mode aredetermined by the settings of its access point device.● Network status — Define whether the network name isdisplayed.● WLAN network mode — Select Ad-hoc to create an adhoc network and to allow devices to send and receive datadirectly; a WLAN access point device is not needed. In anad hoc network, all devices must use the same WLANnetwork name.● WLAN security mode — Select the encryption used:WEP, 802.1x (not for ad hoc networks), or WPA/WPA2. Ifyou select Open network, no encryption is used. The WEP,802.1x, and WPA functions can be used only if the networksupports them.● Homepage — Enter the web address of the starting page.● Use access point — Select After confirmation if youwant the device to ask for confirmation before theconnection using this access point is created orAutomatically if you want the device to connect to thedestination using this access point automatically.To enter the settings for the selected security mode, selectWLAN security settings.Security settings for WEP● WEP key in use — Select the wired equivalent privacy(WEP) key number. You can create up to four WEP keys. Thesame settings must be entered on the WLAN access pointdevice.● Authentication type — Select Open or Shared for theauthentication type between your device and the WLANaccess point device.● WEP key settings — Enter WEP encryption (length ofthe key), WEP key format (ASCII or Hexadecimal), andWEP key (the WEP key data in the selected format).Security settings for 802.1x and WPA/WPA2● WPA/WPA2 — Select the means of authentication: EAPto use an extensible authentication protocol (EAP) plug-in,or Pre-shared key to use a password.Complete the appropriate settings:● EAP plug-in settings — Enter the settings accordingto the instructions from your service provider.● Pre-shared key — Enter a password. The samepassword must be entered on the WLAN access pointdevice.● WPA2 only mode — Only WPA2 enabled devices areallowed to establish a connection in this mode.Connectivity© 2008 Nokia. All rights reserved.72