Nokia 8210 Command List

Also see for 8210: Quick guide Fax setup Quick guide Remote guide Software guide

Contents

Nokia 8210 Command List Manual pdf 11 page image

AT Command Set for Nokia 8210 10Copyright © 2000. Nokia Mobile Phones. All rights reserved.&S Define DSR OptionThis command defines how the DSR V.24 signal is handled. For some products thiscommand is a dummy. In these cases, either the DSR is always ON, or the DSRfollows the DTR. (De facto.)Syntax:AT&S[0] Keep DSR always ON.AT&S1 Enable normal DSR usage. This is thedefault option.&V View Active ConfigurationThis command displays the current values of the S-registers. Values 1 and 2 shall bepresent only when stored profiles are supported. Response format is product specific,but it must fit in a 80x24 character display and all command parameters stored in aprofile must be shown as 'command name'-'values of parameters' pairs (e.g. S7:80).(V.25ter section 6.1.2.)Syntax:AT&V[0] View active configuration. (All commandparameter values defined under &F and&Y settings).AT&V1 Show settings in stored profile 0. (Allcommand parameter values defined under&W).AT&V2 Show settings in stored profile 1. (Allcommand parameter values defined under&W).&W Store ConfigurationThis command stores the current settings to one of two user profiles. Commandparameters (if implemented) that are stored to a profile are the same as listed underthe command &F (see page 9) except the parameters of the following commandswhich are not stored: +CMOD, +CSCA, +CSMP. (De facto.)Syntax:AT&W[0] Store settings to user profile 0.AT&W1 Store settings to user profile 1.&Y Select Power-Up ConfigurationThis command defines from which user profile (0 or 1) parameters are loaded whenthe product is activated. This setting is not included in the settings that are stored in auser profile. The command &F does not affect this setting. (De facto.)Syntax:AT&Y[0] Parameters are loaded from user profile 0.AT&Y1 Parameters are loaded from user profile 1.+++ EscapeDuring on-line data state, the online command state can be entered by giving threesame characters in a sequence. The character is defined by S-register S2. Thedefault character is '+'. Before and after the sequence there must be a pause of atleast the time defined by S-register S12. By setting S12 to zero, escape sequencedetection can be disabled. (De facto.)Syntax:+++ Enter on-line command state.'+' is default character.