Nokia 8210 Command List

Also see for 8210: Quick guide Fax setup Quick guide Remote guide Software guide

Contents

Nokia 8210 Command List Manual pdf 47 page image

AT Command Set for Nokia 8210 46Copyright © 2000. Nokia Mobile Phones. All rights reserved.Result Codespossible verboseresult codes (V1)numeric(V0) descriptionCONNECT 1 data/fax call established; rate 300 bps (or Xforbids rate display)CONNECT 1200 5 data/fax call established; rate 1200 bpsCONNECT 2400 10 data/fax call established; rate 2400 bpsCONNECT 4800 11 data/fax call established; rate 4800 bpsCONNECT 9600 12 data/fax call established; rate 9600 bpsCONNECT 14400 17 HSCSD (or 14.4 tch) data/fax call established;rate 14400 bpsCONNECT 19200 18 HSCSD data/fax call established; rate 19200 bpsCONNECT 28800 19 HSCSD data/fax call established; rate 28800 bpsERROR 4 command cannot be actionedNO CARRIER 3 call could not be establishedOK 0 command abortedB Communications Standard Option (CCITT/Bell mode)This command has no effect on the data software. It is included for compatibilityreasons. (De facto.)Syntax:ATB[] Values for [0]...1.D DialThis command initiates a call. (V.25ter section 6.3.1.) When a call is initiated, thecommand must contain the called party's number or a directory entry which containsthe stored number. The ATD command can also be used for sending DTMF tonesand for switching call mode from voice to data when an alternating call is active.(GSM 07.07 section 6.6 and annexes E and F)When the product tries to reach a number and fails to establish a connection, furtherattempts will be delayed, i.e., successive attempts to dial the same number will berejected for a short period of time, and the response DELAYED will be displayed. Thedelay period only lasts for a few seconds at first, however, if you continue to try to getthe call through and fail, the delay will be prolonged for a few minutes. Finally, thecalled number will be included on a list of so-called blacklisted numbers. Theresponse BLACKLISTED will be seen on the screen. The data software will notaccept any new attempts to that number before you press any key on the cellularphone keypad. This user action erases the number from the list and enables you tocall the number again. The purpose of blacklisting numbers is to conserve thenetwork's resources.NOTE: +VTS command or comma modifier (e.g. "ATD,1234"; in this case the firstcomma do not cause a pause) can be used to send DTMF digits.