A CCESS G ATEWAY86 System Administration14. If required, make this an IP Upsell Pool and/or the Default Pool by checking theappropriate boxes.15. Optional, if the gateway router for the DHCP Pool is other than that of the DHCP ServerIP, select Specify and enter the IP address of the gateway router of choice.16. When finished establishing your DHCP Pools, click on the Back to Main DHCPConfiguration Page to return to the previous page.17. You must now reboot the system for the new settings to take effect. Click the check box forReboot after changes are saved? then click on the Submit button to save your changesand reboot the system, or click on the Reset button if you want to reset all the values totheir previous state.The existing lease pool and lease table are deleted and the Access Gateway reboots. TheAccess Gateway can issue IP addresses to any DHCP enabled subscriber who enters thenetwork.Enabling DNSSEC SupportDNSSEC support adds authentication and integrity capability to DNS systems. The DNSSECfeature in the NSE allows DNSSEC queries and responses to traverse the NSE betweensubscribers and the NSE’s configured DNS servers. The NSE itself does not participate inDNSSEC trust relationships with subscribers. Reboot is not required.Use the following procedure to set the DNS configuration options.1. From the Web Management Interface, click on Configuration, then DNS. The DomainName System (DNS) Settings screen appears:Do not allow pools to overlap.
