Norac UC5 Operator's Manual

Also see for UC5 Topcon X30: Installation manual Installation manual Installation manual Installation manual Installation manual

Norac UC5 Operator's Manual Manual pdf 14 page image

10In manual mode, the height displayed under each boom section is measured from the spraynozzles to the soil (Soil Mode) or crop canopy (Crop Mode or Hybrid Mode). If there are fiveheight sensors on the sprayer, the height displayed is the average for each boom section. Thecrop at the bottom of the screen indicates the mode the controller is in. If the green line isabove the crop, the system is in Crop Mode or Hybrid Mode. If the green line is below thecrop, the system is in Soil Mode.The following applies to Virtual Terminal only:When two or more virtual terminals are connected on the Display Bus, the Move to Next VTbutton will appear on the Soft key area of the Run screen. This button allows the user to selectthe preferred terminal on which to display the UC5 screen. By pressing this button the UC5screen will move to next available terminal.6.3 SettingsTo change the NORAC UC5™ settings, select the Settings button as shown in Figure 6. TheSettings can be accessed at any time, regardless of being Automatic or Manual Mode. Thesecond setting screen is accessed by selecting the Next button as shown in Figure 7. Whenthe system is in Manual Mode more settings and options are available by selecting the Nextbutton as shown in Figure 9. These settings are discussed in later sections. If the system is inAutomatic Mode, the “MANUAL” button is displayed to be able to put the system into ManualMode (Figure 8 and Figure 10) and to change other settings.Figure 7: 1 st Settings Screen in Manual Mode Figure 8: 1 st Settings Screen in Automatic ModeFigure 9: 2 nd Settings Screen in Manual Modewith Learned Crop Height CheckedFigure 10: 2 nd Settings Screen in AutomaticMode with Learned Crop Height Checked