Norac UC5 Operator's Manual

Also see for UC5 Topcon X30: Installation manual Installation manual Installation manual Installation manual Installation manual

Norac UC5 Operator's Manual Manual pdf 16 page image

12fastest reaction time. A reaction time of 0 turns the main lift control off. A slower main liftreaction time can be beneficial in uneven crops to prevent the boom from making unnecessarymovements. A reaction time of zero can be beneficial in tall crops where the crop is beingpushed over by the sprayer chassis to prevent the center section from moving too low.Setting Main Lift Reaction Situation0 Off Tall Crops1 Slowest Reaction Uneven Crops5 Fastest Reaction Even Crops & Soil ModeSlant Reaction:The slant reaction time is how long the slant waits between adjustments. This setting is onlyvisible when the slant control is enabled. The slant reaction time can be adjusted from 0 to 5.A setting of 1 is slow and a setting of 5 is the fastest reaction time. A reaction time of 0 turnsthe slant control off. It is best to set the slant reaction to a low setting in flat fields as the slantis generally not required in flat fields. It is best to set the slant reaction to a higher setting inuneven terrain or on side hills. Setting the slant reaction too high will cause the boom tooscillate and decrease the performance of the system.Learned/Expected Crop Height:The learned crop height setting is used when spraying in Hybrid Mode. When Learned CropHeight is checked, the UC5 system will attempt to learn the average crop height using all cropreadings that are measured by the ultrasonic sensors. If Learned Crop Height is unchecked, theoperator can enter an expected crop height. The expected crop height is then used to try andachieve a more accurate average crop height reading by excluding ultrasonic sensor readingsthat are outside the acceptable distance from the expected crop height. In most situationsleaving the Learned Crop Height setting checked will provide adequate performance.6.4 Sprayer SwitchesWhen a sprayer switch is pressed, an arrow will be displayed on the screen showing whichfunction is being activated (Figure 5). For example, if the left up switch is pressed then anarrow will be shown above the left boom pointing up. Some sprayer types do not support thisfunctionality.Tilt Switches:While in Automatic Mode if either left or right tilt boom switches are pressed, thecorresponding boom section will go into Manual Mode, but other boom sections will remain inAutomatic Mode. To return all boom sections to Automatic Mode, press the “AUTO” button.If the Double Tap Wings function is enabled, the tilt down switches can be used to resumeAutomatic Mode provided that at least one boom section is already in Automatic Mode.