Installing and configuring IP Phones 279c. Press the Select soft key.This reregisters the telephone at the main office.If Resume Normal Mode is not selected, the IP Phone automaticallyreturns to Normal Mode after ten minutes.—End—Installing IP Phones through LD 11To use the Virtual Office feature at the Branch Office in Local Mode, aStation Control Password must be configured. Refer to Procedure 11"Setting and changing the Station Control Password Configuration" (page216) to provision the Station Control Password at the Branch Office. Toprevent user password confusion, Nortel recommends that the same SCPWbe used at the main office and the Branch Office.Procedure 27 "Installing IP Phones through overlays" (page 279) describesthe general method of installing a Branch User IP Phone through LD 11.ATTENTIONIf the installation technician uses TM 3.01 or LD 11 to configure the Branch UserID and Main Office TN for an IP Phone, the IP Phone is automatically redirectedto the main office after it is registered to the Branch Office.Procedure 27Installing IP Phones through overlaysStep Action1 Configure the Branch Office zones and dialing plan. See Procedure23 "Configuring the MG 1000B zone" (page 257). Perform thisprocedure on the MG 1000B Call Server.2 Configure the following telephone data in LD 11:• Terminal type• Customer Number• TN• ZoneTo automatically redirect the IP Phone to the main office, configure aBUID and its MOTN. The BUID and MOTN prompts are unique to theBranch Office feature. Leave the MOTN field blank if it has the samevalue as the Branch Office TN. If a BUID is not entered, MOTN is notprompted. In this case, Branch User configuration is still required.Nortel Communication Server 1000Branch Office Installation and CommissioningNN43001-314 01.02 StandardRelease 5.0 20 June 2007Copyright © 2007, Nortel Networks.
