Nortel 1000 Con?guration guide Manual

Also see for 1000 Con?guration guide: Brochure Reference User manual Overview User guide

Contents

Nortel 1000 Con?guration guide Manual Manual pdf 99 page image

99MaintenanceContents This section contains information about the following topics:"Introduction" (page 99)"CS 1000 CLI commands" (page 99)"MCS 5100 tools" (page 101)"Translation Verification tool" (page 101)Introduction This section contains CS 1000 Command Line Interface (CLI) commandsthat can be used with CDS. The CS 1000 CLI commands are used from theSignaling Server CLI.This section also contains a diagnostic tool available on MCS 5100 forverifying translations.CS 1000 CLI commandsThe CS 1000 Signaling Server provides a Command Line Interface (CLI)through a serial port or a Telnet session. This section contains the CLIcommands available at that interface that are applicable to CDS.Signaling Server CLI commands are available at three levels:• Level One — Operations, Administration, and Maintenance (OAM)shell for basic technician support and general status system checking(oam>prompt)• Level Two — Problem Determination Tool (PDT) shell for expert support;also includes all Level One (OAM) commands (pdt>prompt)• Level Three — Nortel proprietary vxWorksª shell for advanceddebugging and design support (prompt)Note: This section describes the Level One (OAM) and Level Two(PDT) CLI commands. Level Three commands are considered expertsupport and design level commands, and are not documented here.Nortel Communication Server 1000Communication Server 1000 to MCS 5100 Converged Desktop Type 2 Configuration GuideNN43001-321 01.05 StandardRelease 5.0 15 February 2008Copyright © 2005-2008, Nortel Networks.