166 Media Card maintenanceMaintenanceDisplayCorresponding CriticalError Message DescriptionS002 ITS1002 Connect service activation error .S003 ITS1003 Duplicate master .S004 ITS1004 Invalid node ID .S005 ITS1005 Corrupted node ID/TN field .S006 ITS1006 Received corrupted UNIStim message dump>.S007 ITS1007 Received unknown UNIStim message dump>.S008 ITS1008 Terminal connection status: .S009 ITS1009 Call Server communication link:.S010 ITS1010 Terminal doesn’t support Codec:.S011 ITS1011 : Last reset reason for phone: ().Replacing a Media CardReplace the Media Card when the following conditions occur:• After a reboot, the Media Card displays a fault code of the form F:xxon the faceplate LED display and the card cannot register with the CS1000E. This indicates an unrecoverable hardware failure.If the Media Card displays the F:08 code, this can merely indicate thatthe Security Device is missing from the card.• The management Ethernet interface or the voice Ethernet interface onthe Media Card fails. The failure is originating in the Media Card if itsassociated hub port and TLAN network interface cable are operational.The failure can be indicated as follows:— No link pulse on the Media Card voice IP interface status LED andon the associated hub.— The maintenance terminal continuously prints lnIsa0 Carrier Failuremessages.• A voice channel on the Media Card has a consistent voice quality fault,such as persistent noise or lack of voice path, even after resetting thecard and retransmitting the card properties.To replace a Media Card, see IP Line Fundamentals (NN43100-500).Verify Media Card software and firmwareTo verify the Media Card software and firmware, see IP Line Fundamentals(NN43100-500).Nortel Communication Server 1000Communication Server 1000E MaintenanceNN43041-700 01.02 StandardRelease 5.0 20 June 2007Copyright © 2007, Nortel Networks.
